Lump Breaker
Our lump breaker is designed to reduce large clumps of agglomerated material into a smaller, more uniform, particle size to improve downstream processing and/or conveying characteristics. It should not be considered a true size reduction machine that will grind materials to a specific size.
Progressive Products, Inc recommends testing should be done on all material to confirm size selection. It is also recommended that level sensors be used downstream of the lump breaker to prevent over-filling of the feeding device being used.
Stacks Image 2945
Design Standards

Lump Breaker - 12" x 12" SS

  • 304 SS, 2b finish construction
  • 12" x 12" inside square inlet and outlet
  • Two (2) 304 SS shafts with 304 SS, 1/2" square, fingers
  • Two (2) sets of 304 SS, 1/2" square, fingers welded to housing exterior
  • Outboard bearings with concentric locking collar
  • External seals
  • Factory assembled rotor shaft air purge assembly complete with single solenoid air control valve, regulator, and interconnecting air line - NEMA 4 enclosure
  • Gear guard painted safety orange
  • 2HP drive assembly with 230/460 VAC, 3 phase, 60 Hz motor, TEFC, and drive guard

Carbon Steel, 316 SS, and 24" x 24" models available